Philips CD 931 - Manual (Page 7)

OPERATION PROGRAMMING ®
SCANNING A CD (SCAN)
• Press SCAN before or during play.
" If the CD compartment was open, it will now close.
- 5
lh I I lights up and the first 10 seconds of each track are
played in turn.
- 10 seconds are counted down each time under TRACK
TIME.
• When the player reaches a track which you wish to hear in
full, press SCAN again or PLAY/REPLAY.
Other scan times can be entered in the PRESETS mode. For
this refer to 'PERSONAL PRESETS' on page 9.
PLAYING THE CD IN RANDOM ORDER (SHUFFLE)
• Press SHUFFLE before or during play.
- If the CD compartment was open, it will now close.
- SHUFFLE lights up and all the tracks are now played in a
random order.
- SHUFFLE lights up before each new track.
• Press SHUFFLE again if you wish to return to normal play.
If you press !◄ TRACK, you will return to a track which has
already been played.
If you press TRACK ►!, you will select any one of the following
tracks.
If you press REPEAT, twice the tracks will be repeated in a
different order each time, although the first track played will
always be the same.
REPEATING A TRACK (REPEAT)
• Press REPEAT before or during playback.
- REPEAT 1 lights up; the track will now be repeated continuously.
• Press REPEAT twice to stop the track being repeated.
REPEATING THE CD (REPEAT)
• Press REPEAT twice before or during playback.
- REPEAT lights up; the CD will now be repeated continuously.
• Press REPEAT again to stop the CD being repeated.
CALLING UP OTHER TIME INFORMATION (TIME)
Press TIME whenever you want to know the remaining
playing time of the track being played (REM TRACK TIME).
Press TIME again if you wish to know the remaining playing
time of the entire CD (TOTAL REM TIME).
Press TIME again if you wish to return to the elapsed playing
time indication of the current track (TRACK TIME).
SETTING THE FADE- IN AND FADE-OUT TIME (FADER)
NOTE!
The FADER function can only be used if the player is
connected to the amplifier or the system via the ANALOG
OUT output.
"o)
c
Hi
• During .play press FADER.
- FADER lights up and lliiu. starts flashing.
- The sound level will now gradually decrease (FADE OUT),
after which the player will go into the PAUSE mode.
• Press FADER again.
- .lililí starts flashing; play continues and the sound level will
increase again to the originally set level (FADE IN).
Other fade times can be entered in the PRESETS mode. For
this refer to 'PERSONAL PRESETS' on page 9.
ADJUSTING THE SOUND LEVEL (-VOLUME +)
IMPORTANT!
- Use the - VOLUME + keys (on the remote control) only if
the player is connected to an amplifier or HiFi system
without \ts own remote control.
- The setting chosen with - VOLUME +will remain stored
in the player's memory, even if the player is switched off.
• Hold - VOLUME pressed down.
- l-'OLUt1E lights up; the output signal from the player will
now decrease gradually.
- The successive steps are shown on the display.
• Release the key as soon as the required sound level is obtained.
• Hold VOLUME + pressed down.
- l-'OLUNE lights up; the output signal will now increase again
gradually to the maximum level.
• Release the key as soon as the required sound level is obtained.
INSERTING AN EXTRA PAUSE (AUTO SPACE)
• Press AUTO SPACE.
- AUTOSPACE lights up; during play an extra pause will be
inserted between the various tracks.
• Press AUTO SPACE again to delete the extra pause.
Other pause times can be entered in the PRESETS mode.For
this refer to 'PERSONAL PRESETS' on page 9.