Philips CD 931 - Manual (Page 11)

SYSTEM ASPECTS
ENHANCED SYSTEM INTELLIGENCE (ESi) STAND BY
It the player is connected via the ESI BUS sockets to the
ESI
BUS sockets of a HiFi system (e.g. the PHILIPS 900
series), the player can be operated via the remote control of
the system. In addition, the functions mentioned below are
then accessible (if available in the system):
NOTE!
When connecting the ESI BUS to the ESI BUS of the HiFi
system the CD player should be switched off.
CD DUBBING (synchronized recording]
• Set the player to the STOP, EDIT or EDIT OPTIMAL mode.
• Press CD SYNC. (CD DUBBING) on the cassette deck.
- Playback starts but nothing is being recorded yet; you can
now adjust the recording level.
• Press PLAY on the deck.
- Recording starts and after 6 seconds play starts again at the
beginning of the CD or the programme.
~ After each track the pause time set in the PRESETS mode
(AUTO SPACE) will be inserted.
- At the end of side A of the tape, play will stop; the current
track will be recorded again on side B of the tape (except
when EDIT or EDIT OPTIMAL is active).
- After the last track playback and recording will stop.
• With the STAND BY button on the remote control of the
system you can set the player to STAND BY mode.
The player will go to STAND BY mode automatically if the
whole system is set to STAND BY mode.
- If the CD compartment was open, it will now close.
- Any programme present will be erased.
• Press any of the following buttons to cancel the STAND BY
mode:
PUkY/REPLAY, STOP/CP, SCAN, SHUFFLE, 1-0, EDIT,
OPEN/CLOSE, !◄ TRACK ►!, FTS, PRESETS or
PRG(program).
£
"5)
c
HI
TIMER
Using the TIMER function you can have playback (of a CD or
a programme) started at a particular time; for this refer to the
operating instructions of the tuner (e.g FT930).
TIHER CANCELLED lights up if there is no CD in the CD
compartment at the moment playback is supposed to start
or if you press any button during playback in the TIMER
mode.
NOTE!
As soon as you start recording, the other player functions
(except TIME and REVIEW) will temporarily be switched
ott to prevent the recording being interfered with;
I
11 01 litT: I j 10 FiC r n 'E lights up if you press one of the
other buttons during play/recording.
You can stop playback/recording by pressing STOP/CP or
OPEN/CLOSE, CO - 0006 i i 1C COi ICELLEu then lights
up
During dubbing the volume set with - VOLUME + will be
cancelled and returned to the sound level set on the
amplifier,
The - VOLUME + keys may not be used during dubbing
as they affect the strength of the signal from the player.
The CD DUBBING function will be cancelled if the CD
player (or the system) is set to STAND BY mode
AUTOMATIC SOURCE SELECTION
If the AUTO SELECT button on the amplifier is pressed, the
CD player will automatically be activated as soon as you press
PLAY/REPLAY, SCAN or SHUFFLE.
AUTOMATIC STOP
If the AUTO SELECT button on the amplifier is pressed, the
CD player will automatically go into the PAUSE mode as soon
as another source in the system is selected (except when
EDIT or CD DUBBING is active).
11