Philips AZ 2804 - Manual (Page 9)

TUNER
iTuning to radio stations
1 Select the tuner mode by pressing the CD»TAPE«TUNER button
several times until Eama appears on the display.
2 Select the wave band by using the BAND selector.
-► Display indication: the selected waveband
3 Press TUNING or»>i for approx, one second and then release
the button.
-► The radio automatically tunes to a station with sufficent
strength. Display indication during automatic tuning: Sr -r l->
4 Repeat this procedure until you find a desired station.
To tune to a weak transmitter briefly press TUNING or^w as
often as necessary for optimum reception, or until the correct
frequency is indicated in the display.
Improving TUNER reception
• For FM , pull out the telescopic antenna. To improve the signal,
incline and turn the antenna. Reduce its length if the signal is
too strong (very close to a transmitter).
• For AM, direct the built-in antenna by turning the whole set. The
telescopic antenna is not needed.
I
npcn
I LIUUU
5r ch
jSwitchable tuning grid (not all versions)
In North and South America the frequency step between adjacent
channels in the AM band is 10 kFlz. In the rest of the world this
step is 9 kFlz. Usually this frequency step has been preset in the
factory of your area.
In some versions the frequency step can be changed:
• Keep the BAND selector button pressed tor more than 5
seconds.
The display shows either iO C<>- -'o'or S' Gr id.
jProgramniing radio stations (29 preset stations)
You can store up to 29 radio stations in the memory. When tuning
to a preset station, the preset number (1 to 29) is indicated in the
display.
1 Select the tuner by pressing the CD»TAPE»TUNER button
several times until nsEEa appears on the display.
2 Tune to a desired station with TUNING r« or^w, as described
earlier.
-► If the frequency is already stored in the memory, the preset
number will be displayed.