Philips AZ 2804 - Manual (Page 7)

CONTROLS POWER SUPPLY
Remote control
OPEN
►II
............ to open/close the CD tray
. to start and to interrupt CD play
........... -CD Mode: to select the beginning of the
current/previous or a subsequent track
- TUNER Mode: to select a preset station
■ .....................to stop CD play
VOLUME ▼ A ............. to increase or decrease the volume level
S)
c
UJ
Batteries
Set (R20, UM1 or D-cells):
• Open the battery compartment of the set and insert six batteries,
type R20, UM1 or D-cells (preferably alkaline).
Remote control (R06, UM3 or AA-cells):
• Open the battery compartment of the remote control and insert
two batteries, type R06, UM3 or AA-cells (preferably alkaline).
• Remove the batteries if they are exhausted or the set is not to be
used for a long time.
All kinds of batteries contain chemical substances
therefore they should be disposed of properly.
'Mains
1 Check if the mains voltage as shown on the type plate
corresponds to your local mains voltage. If it does not, consult
your dealer or service organisation. The type plate is located
at the base of the set.
If the set is equipped with a VOLTAGE selector (x), set this
selector to the local mains voltage.
2 Connect the mains cable to the AC MAINS inlet and the wall
outlet. The AC power supply is switched on. The mains cable
is inside the battery compartment
The battery supply is switched off when the set is connected to the
mains. To change over to battery supply, pull out the plug from the
unit's AC MAINS inlet.
To disconnect the set from the mains completely, withdraw the
mains plug from the wall outlet.