Setting your philips cd rewriter as the master, Setting the philips cd rewriter as the slave, Csel (cable select) – Philips PCRW404K/17 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting your Philips CD Rewriter as the MASTER
As shown in the diagram at the right, insert the jumper pin into
the right edge of the jumper switch.
Note:
If only your Philips CD Rewriter will be connected to
the IDE interface connector, connect the Philips CD
Rewriter to the end of the connector.
) OUT
3 L
"1 1
-----CSEL
I—SLAVE
rMASTER
o □
Setting the Philips CD Rewriter as the SLAVE
As shown in the diagram at the right, insert the jumper pin into
the middle of the jumper switch.
> OUT
3 L
1 1
-----CSEL
I—
SLAVE
rMASTER
2
b
B
°:
CSEL (Cable SELect)
If you choose the CSEL setting, the MASTER7SLAVE setting will be made automatically
depending on your hardware configuration. For details refer to the user manual of your
computer.