Basic functions radio – Philips AZ8061 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BASIC FUNCTIONS

RADIO

e/5’

Switching on and off/standby

• Set the POWER selector to the desired sound source;

CD-TAPE-RADIO.

• The set is switched off when the POWER selector is in position

TAPE/OFF and the recorder keys are released.

• In order to switch off the power supply, remove the mains plug.

Note: When operating the set with batteries, always be sure to

set the POWER selector to position TAPE/OFF when the set is not

used. This will avoid a permanent power consumption.

Adjusting volume and sound

Adjust the sound using the controls VOLUME and DBB or

3 BAND GRAPHIC EQUALIZER.

The bass frequencies can also be emphasised if you place the set

against a wall or bookshelf. (Do not cover any vents and leave

sufficient room around the unit for ventilation.)

AZ8060
AZ8061

AZ8062

RADIO - tuning to radio stations

1 Set the POWER selector to RADIO.

2 Select the wave band by using the selector FM-MW-LW.

3 Tune to the desired radio station by using the TUNING knob.

Improving the RADIO reception

For

FM,

pull out the telescopic antenna. To improve the FM

signal, incline and turn the antenna. Reduce its length if the

signal is too strong (very close to a transmitter).

For

and

LW,

direct the built-in antenna by turning the whole

set. The telescopic antenna is not needed.

This manual is related to the following products: