Philips AZ8061 - Manual (Page 5)

POWER SUPPLY
Batteries, R20 UM1 or D cells
W
s
LU
• Open the battery compartment and insert six batteries, type
R20, UM-1 or D-cells (preferably alkaline).
• Remove the batteries if they are empty or the set is not to be
used for a long time.
Mains
1 Check if the mains voltage as shown on the type plate (on the
base of the set) corresponds to your local mains voltage. If it
does not, consult your dealer or service organisation.
If the set is equipped with a VOLTAGE selector (g), set this
selector to the local mains voltage.
2 Connect the mains lead to the MAINS outlet and the wall socket.
The mains supply is switched on.
• The battery supply is switched off when the set is connected to
the mains. To change over to battery supply, pull out the plug
from the unit's MAINS socket.
To disconnect the set from the mains completely, withdraw
the mains plug from the wall socket.
For users in the U.K.: please follow the instructions on page 2.
The typeplate is located on the base of the set.
Environmental information
All redundant packaging material has been omitted. We have done our outmost to make the packaging
easy separable into three mono materials: cardboard (box), expandable polystyrene (buffer) and
polyethylene (bags, protective foam sheet).
Your set consists of materials which can he recycled if disassembled by a
specialized company. Please observe the local regulations regarding the disposal
of packing materials, exhausted batteries and old equipment.