Philips FWC380 - Manual (Page 49)

■■I I UI 1 i_ vviLi I /
right will be displayed.
CLOCK TIMER
View Clock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD,TUNER,
etc.). The clock will be displayed for
about seven seconds.
• Press CLOCK-TIMER briefly (on
the system only).
“Gi'" in - GO ^ ^ - G G • G O ” /'fko
n I lU’-iiG o r i _ u - _ i u (^ine
current time) will be displayed
depending on whether you have
selected 12- or 24-hour mode.
will be displayed if the
dock is not set.
Clock Setting
The clock can be set in either 12- or
24-hour mode, e.g. ‘‘Rl''l Id ■[][]“ or
“uu'uu“. Before setting the clock, you
must be in the View Clock mode.
1 Press CLOCK-TIMER to select
clock mode.
2 Press PROGRAM to select 12- and
24- hour mode.
If 12-hour mode is selected,
"Fir'l IdublQ“ starts flashing.
“♦ If 24-hour mode is selected,
“D u - ulj ” starts flashing.
3 Set the hour with or ►► on the
system.
4 Set the minute with M or H on the
system.
5 Press CLOCK-TIMER again to
store the setting.
^The clock starts.
• To exit without storing the setting,
press ■ on the system.
Notes:
- During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically.
- When a power interruption occurs, the
clock setting Is erased.
Timer Setting
• The system can switch on to CD ,
TUNER orTAPE mode automatically
at a preset time. It can serve as an
alarm to wake you up.
• Before setting the timer make sure
the clock is set correctly.
• The timer will always be switched on
once it is set.
• The volume of the timer will
increase from the minimum
level to the most recently
selected volume level.
1 Press and hold CLOCK-TIMER
for more than two seconds to
select timer mode.
"T I I I r i c - u u o r U U ' U U Ortn6)3St
timer setting starts flashing
depending on whether you have
selected 12- or 24-hour mode.
^The TIMER starts flashing.
->The selected source is lit while
other available sources are
flashing.
2 Press CD . TUNER or TAPE to
select the desired source.
• Before selecting CD orTAPE, make
sure a disc or tape is loaded in the
CD tray or tape deck 2.
3 Press or ►► on the system to set
the hour for the timer to start.
4 Press M or W on the system to set
the minute for the timer to start
5 Press CLOCK-TIMER to store
the start time.
->The timer is now set
^The TIMER remains on the display.
• At the preset time, the timer will be
activated.
^The selected source will be
played.