Recording, One touch recording, Cd synchro start recording – Philips FWC380 User Manual
Page 47: Recording from other, Digital recording via digital out, Dubbing tapes, Recording from other sources
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECORDING
- If
"CHECK TREE"
is displayed, the
protection tab has been broken. Put a
piece of clear adhesive tape over the
opening.
One Touch Recording
• For One Touch Recording, as soon as
you press RECORD, the current
source (CD,TUNER or AUX) will be
recorded on tape deck 2.
1
Load a blank tape in tape deck 2.
2 Press RECORD to start recording.
-►The REC starts flashing.
3
Press ■ to stop recording.
Note:
- When you press RECORD while in
TAPE mode,
'SELECT SEILIEEE"
will
be displayed. One Touch Recording is
not possible in TAPE mode.
CD Synchro Start
Recording
1
Load a blank tape into tape deck 2
and a disc into a disc tray.
2
Press CD to select CD mode.
• You can program the tracks in the
order you want them to be recorded
(see ProgrammingTracks). If not,
select the disc by pressing CD (CD
1 * 2 * 3 ) and the tracks are recorded
according to the order on the
selected disc.
3
Press RECORD to start recording.
“♦The REC starts flashing.
• Disc will start playback automatically.
4
Press ■ to stop recording.
------------------------------------------------------------ ^
Dubbing tapes
(from tape deck 1
to tape deck 2)
1
Press TAPE (TAPE 1 *2 ) to select
tape deck 2.
2
Load the prerecorded tape into tape
deck 1 and a blank tape into tape
deck 2 with full spool to the left.
3
Press DUBBING
with ">" scrolling right will
be displayed.
• Dubbing will start immediately.
-♦The REC starts flashing.
4
Press ■ to stop dubbing.
Notes:
- At the end of side A, flip the tapes to
side B and repeat the procedure.
- Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
- To ensure good dubbing, use tapes of
the same length.
- You can switch to other source while
dubbing.
Recording from other
sources
(only on tape deck 2)
1
Load a blank tape into tape deck 2
with the open side downward.
2
Press CD, TUNER or AUX
• Start playback of the selected source.
3
Press RECORD to start recording.
-♦The REC starts flashing.
4
Press
■
to stop recording.
Notes:
- During recording, it Is not possible to
listen to another source.
Digital Recording via
Digital Out
For CD digital recording, please refer to
the Instructions Manual of the CD
Recorder, digital audio equipment, etc.