Philips AZ2605 - Manual (Page 6)

SPEAKERS OPERATION
REMOVABLE SPEAKERS
Attaching the speakers
• Slide the speakers down into the sleeves on the sides of the set
cabinet. The speakers will click into position.
Taking off the speakers
• Keep the lever (found on the back corner of the speaker) pressed and
slide the speaker upwards.
Connecting the speakers
1. Connect the right speaker to the terminal R, with the red marked wire
to + and the black wire to -.
2. Clip the exposed portion of wire into the corresponding colour terminal.
3. Repeat the wiring procedure for the left speaker to terminal L, making
sure that you connect the red wire to + and the black wire to -.
Positioning the speakers
The ideal position is obtained when the 2 front speakers and the listening
position build an equilateral triangle and the speakers are at ear-height.
Note:
- Speakers with an impedance of 4 ohms or higher other than as
supplied may be used instead. Do not, however, use speakers with a
lower impedance as this will result in damage to your set.
- When headphones are connected with the headphone sockets
the speakers are disconnected.
OPERATION
General operation
7. To switch on the set, set the source by using the source selector®.
2. Adjust the sound using the VOLUME AT®, TONE @ and DBB @
controls.
3. To switch off the set, set the source selector® to TAPE/OFF position,
with the cassette keys released.