Philips AZ2605 - Manual (Page 13)

TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Under no circumstances should you tty to repair the set yourself, as this would invalidate the
guarantee.
PROBLEM Severe radio hum or noise
-
POSSIBLE CAUSE
• REMEDY
Set does not react to operation of
any of the controls_____________________________
-
Electrostatic discharge.
• Switch off the set, disconnect the mains plug and
reconnect after a few seconds.
Display does not function properly__________________
-
Electrostatic discharge.
• Switch off the set, disconnect the mains plug and
reconnect after a few seconds.
-
Set runs on batteries.
• Switch to mains supply.
No sound_______________________________________
-
VOLUME is not adjusted.
• Adjust the VOLUME.
-
Headphones are connected.
• Disconnect headphones.
-
Batteries are exhausted.
• Insert fresh batteries.
-
Batteries are incorrectly inserted.
• Insert the batteries correctly.
-
Mains lead is not securely connected.
• Connect the mains lead properly.
Bad sound______________________________________
-
Unsuitable speakers are used.
• Use supplied speakers.
-
Batteries are exhausted.
• Replace batteries.
Poorhasssound_________________________________
-
Speakers not in phase.
• Connect speakers poles correctly, V to V ; t o
No sound on left or right side____________________
-
Speaker wrongly connected.
• Connect speaker properly.
Reversed left and right sound____________________
-
Speakers are wrongly connected.
• Connect speakers properly, L to left, R to right.
-
Set too close to TV, VCR or computer.
• Increase the distance.
Poor radio reception
-
Weak radio signal.
• FM: aim and extend the telescopic aerial for best
reception;
• MW/LW: rotate the entire set.
Poor cassette sound quality__________________________
-
Dust and dirt on the heads, capstan or pressure
roller.
• Clean the heads etc., see Maintenance.
-
Use of incompatible cassette types ¡METAL or
CHROME).
• Only use NORMAL (lEC I) for recording.
Recording does not work
-
Cassette tab(sj may be broken out.
• Apply a piece of adhesive tape over the missing
tab space.
CD playback does network_________________________
-
CD is badly scratched or dirty.
• Replace or clean the CD, see Maintenance.
-
No CD inserted.
• Insert CD.
-
CD inserted upside down.
• Insert CD with printed side facing up.
The CD skips tracks
-
Laser lens is steamed up.
• Wait until lens has acclimatized.
-
CD is damaged or dirty.
• Replace or clean the CD.
-
PROGRAM/SHUFFLE is active.
• Switch off the PROGRAM/SHUFFLE function.
Remote control does not function properly * •
-
Batteries are exhausted.
• Insert new batteries.
-
Batteries are incorrectly inserted.
• Insert batteries correctly.
-
Distance between the set is too large.
• Reduce the distance.
13