Philips AZ2605 - Manual (Page 12)

MAINTENANCE
PRECAUTIONS & GENERAL MAINTENANCE
- Place the set on a hard, flat surface so that it does not tilt.
- Do not expose the set, CDs, batteries or cassettes to humidity, rain,
sand, direct sunlight or other places where high temperatures can
occur, such as in the vicinity of heating apparatus or in motor cars
parked in the sun.
- Do not cover the set. The amplifier produces heat which must dissipate
freely, so make sure that there is sufficient ventilation around the set.
A minimum gap of 15 cm is necessary.
- The mechanical parts of the CD player and the cassette deck contain
self-lubricating bearings and must not be oiled or lubricated.
- A chamois leather slightly moistened with water is sufficient for
cleaning the housing. Do not use cleaning agents containing alcohol,
spirits, ammonia or abrasives as these may harm the housing.
CD MAINTENANCE
- The lens of the CD player should never be touched.
- The lens may cloud over if the CD player is moved from cold to warm
surroundings. The CD player will not start. Give the player some time to
acclimatise.
- To take a CD out of its box, press the centre spindle while lifting the
CD. Always pick up the CD by the edge and replace the CD back in its
box after use to avoid scratching and dust.
- To clean the CD, wipe in a straight line from the centre towards the
edge using a soft, lint-free cloth. Do not use cleaning agents as they
may damage the disc.
- Never write on a CD or attach stickers to it.
RECORDER MAINTENANCE
To ensure a good recording and playback quality, clean the indicated parts
®.(|) and @ after every 50 hours of operation or, on average, once a
month. Use a cotton bud slightly moistened with alcohol or a
special head cleaning fluid.
• Press PLAY ► and clean the rubber pressure rollers
• Then press PAUSE ll and clean the capstans (|) and the heads ®.
• After cleaning, press STOP* OPEN ■ 4.
Cleaning of the heads ® can also be done by playing a cleaning
cassette through once.
This set complies with the radio interference requirements of the
European Community.
The type plate is located on the base of the set.
12