Interlogix GE-DSH-73 Series Installation Sheet - Manual (Page 8)

Figure 7: Set IP address screen
3. Repeat Step 2 to check if the IP address is changed.
If the IP is successfully configured, the Managed Industrial Switch will apply
the new IP address setting immediately. You can access the Web interface
of Managed Industrial Switch through the new IP address.
Note: If you are not familiar with console command or the related parameter,
enter "?" anytime in console to get the help description.
Telnet Setup
1. Connect an RJ-45 cable from the PC to a Switch port on the Managed
Switch.
8 of 13 P/N 1069666-EN • REV 1.01 • ISS 14JUL10