Interlogix ES3001-4P-4T - Manual (Page 9)

IFS ES3001-4P-4T User Manual
9
3. Hardware Installation
Before start up
Before your installation, please refer to the followings for your cabling:
10/100/1000Base-T
All 10/100/1000Base-T ports come with Auto-Negotiation capability. They automatically support 1000Base-T, 100Base-TX
and 10Base-T networks. Users only need to plug a working network device into one of the 10/100/1000Base-T ports, and
then turn on the ES3001-4P-4T. The port will automatically runs in 10Mbps, 20Mbps, 100Mbps or 200Mbps and 1000Mbps
or 2000Mbps after the negotiation with the connected device.
Cabling
Each 10/100/1000Base-T ports use RJ-45 sockets -- similar to phone jacks -- for connection of unshielded twisted-pair
cable (UTP). The IEEE 802.3 / 802.3u 802.3ab Fast / Gigabit Ethernet standard requires Category 5 UTP for 100Mbps
100Base-TX. 10Base-T networks can use Cat.3, 4, 5 or 1000Base-T use 5/5e/6 UTP (see table below). Maximum distance
is 100meters (328 feet).
Port Type Cable Type Connector
10Base-T Cat 3, 4, 5, 2-pair RJ-45
100Base-TX Cat.5 UTP, 2-pair RJ-45
1000Base-T Cat.5/5e/6 UTP, 2-pair RJ-45
Any Ethernet devices like hubs/ PCs can connect to the ES3001-4P-4T by using straight-through wires. The
eight-10/100/1000Mbps ports are auto-MDI/MDI-X can be used on straight-through or crossover cable.
3.1 Desktop Installation
To install the Switch on desktop, simply follow the next steps:
Figure 3-1: Attaching the rubber feet to the Gigabit Ethernet Switch