Interlogix MC355-1T/1S User Manual - Manual (Page 15)

IFS MC355-1T/1S User Manual 11
3. Assemble the wall mount plate on the MC355-1T/1S.
4. Use the hook holes at the corners of the wall mount plate to hang the MC355-
1T/1S on the wall.
Stand-alone Installation
MC355-1T/1S Installation:
To install the MC355-1T/1S with 1000Base-SX / LX SFP, simply complete the
following steps:
1. Connect the DC power to the MC355-1T/1S and verify that the Power LED
illuminates.
2. Turn on the power of the device/station; the PWR LED (Green) should
illuminate when all cables are attached.
3. Make sure that both ends of the fiber cable is connected to the same type of
SFP transceiver, i.e. the 1000Base-SX / 220m & 550m to 1000Base-SX /
220m & 550m, 1000Base-LX / 10km to 1000Base-LX / 10km
4. Connect the fiber cable. Attach the duplex LC connector on the network cable
into the SFP transceiver.