ILY FORTRESS CD/DVD Duplicator System - Manual (Page 5)

10.8 Update BIOS Updates the firmware for the controller.
Note: Please make sure that the firmware is approved by the manufacturer and
compatible with the duplicator before performing the update.
10.9 Copy Count Counts the number of successful and failed copies of CD and DVD made by
the duplicator.
SETUP
11.1 Power On Time Sets system warm up time from 5 sec to 99 sec. Default is 15 seconds.
11.2 Auto Start Sets auto start time from OFF (no auto start) to 99 sec. Allows the duplicator to
automatically start one of six following functions once the master disc and
desired number of target disc(s) are inserted and the drive trays are closed:
Copy, Test, Copy & Verify, Copy & Compare, Verify and Compare.
11.3 Startup Menu Assigns a command to be displayed first after the duplicator has been
initialized.
11.4 Display Mode Sets the amount of information displayed on the LCD during the performance
of various functions.
11.5 Button Beep Enables or disables the audio feedback when buttons are pressed.
11.6 Skip Read Error Enables the option to halt the duplication process if there is an error on the
master disc. Disables the option to allow the process to continue with the same
errors as the master disc.
11.7 Eject on Start Allows the duplicator to eject disc tray(s) with disc present inside upon boot-up.
11.8 Show Copy Time Enables or disables the copy time to be displayed when the copy process is
finished. Also allows for the various other timed functions to display the
completion time.
11.9 Reader Speed Sets the speed at which discs are read during various processes.
11.10 Compare Speed Sets the speed at which the compare process is executed.
11.11 Change Bad Master Enables or disables changing of a master disc during the copy process when
an error is detected on the master disc.
11.12 CD Overburn Enables or disables the duplication of overburned CDs.
11.13 Copy CD-TEXT Enables or disables the copying of the CD subcode (CD-TEXT) information for
audio CDs.
11.14 Show HDD Image
Name
Allows the image name to be displayed on the LCD screen when selecting the
HDD as the source drive.
11.15 Boot Password Sets password protection for duplicator boot-up.
11.16 Setup Password Sets password protection for changing setup options.
11.17 Language Allows different language selections for LCD display.
11
11.18 Clear Setup Clears the CMOS and resets the duplicator controller back to factory defaults.
IMAGE MANAGER The management for various functions of the hard disk drive (HDD).
Note: For this function and submenu to be displayed, a HDD must be installed
in the duplicator.
12.1 Select Image Selects an image file as a source to be copied to the discs.
12.2 Disc → Image Loads an image to the HDD from a master CD or DVD as an Image file.
12
12.3 Set Reader Speed Sets the speed of data loading from the master CD/DVD to the HDD.
3