ILY FORTRESS CD/DVD Duplicator System User Manual

Page 20

In order for the DiscLock Feature to be successfully implemented on your DVD-R discs, 40 MB of
free space must be allocated on the blank DVD-R discs.

The DiscLock feature is only used for DVD to DVD (disc-to-disc) copying. The HDD-to-disc copying
cannot support this feature as the HDD cannot be used in conjunction with the DiscLock feature.

This feature is only for the DVD-Video format only. DVD-Data and other formats are not supported
at this time but may be supported with a firmware revision in the future.

The menu options are as followed when the DiscLock feature is enabled:

DiscLock Copy: The DiscLock copy function is the copy function with the DiscLock protection protocol to
be implemented on the copied disc(s).

Î Press ENT to load

disc and execute

copying

О Analyzing

source disc

О Start Copying О

О Finished and

eject discs

Set Burn Speed – This feature allows you to set the burn speed of DVD with DiscLock feature
implemented (1, 2, 2.4, 4, 6, 8, 12, 16, 18, 20, MAX).

Press ENT &

i, j

Î Press ENT

Select Source – This command will allow you to change the source drive to any one of the drive(s)
inside the unit, including the HDD (if installed). The DVD-ROM drive is the default source drive.

Î Press ENT О

О Press i, j to select О

О Press ENT to finish setting

• Note: If HDD was selected as Source, then follow the instructions on “Select Image” to select

specific image files as your reading source..

• Note: Each drive will be assigned a Drive # according to the installation sequence. If there is no

HDD installed, then the Reader Drive is automatically set as Drive#1.

• Note: The DiscLock feature is only available for DVD to DVD (disc-to-disc) copying. The HDD-to-

disc copying cannot support this feature as the HDD cannot be used in conjunction with the
DiscLock feature.