CatEye EC-3600 - Manual (Page 41)

Cateye Ergociser Series 1000 Service Manual
39
EC-1200 EC-1600 EC-3600 EC-3700 Applicable Models:
MS-3
MS-3
Adjusting the Flywheel
Adjustment Method of Flywheel
Since the plain belt which delivers the rotation of both the workload
unit and flywheel requires an adequate tension, a specified tension
should be given to the plain belt in the following adjustment
procedures. For this adjustment, use commercial tools, since no
purpose-designed tool is not prepared.
1. Set a commercial wire around the flywheel metal base as
depicted in Fig. 1, and tie up the both ends outside the frame.
2. Hang a commercial spring scale at the top of the wire thus tied
up, and lift the scale upward with a pulling force of 5 to 6 kg.
3. Keeping this status, fully tighten the four metal base fixing
screws which had been fastened provisionally. (Fig. 2)
Fig. 1
Spring Scale
Flywheel
Wire
Metal Base Fixing Screws
Flywheel Metal Base
Fig. 2
Metal Base Fixing Screw
Flywheel Metal Base
Adjusting the Flywheel