beautypg.com

Es-4, On off, Correcting the position of solenoid coil – CatEye EC-3600 User Manual

Page 30

background image

Cateye Ergociser Series 1000 Service Manual
28

EC-1200 EC-1600 EC-3600 EC-3700

Applicable Models:

I

mA

I

mA

ON

OFF

ES-4

Perform the positional correction of the core slit section after

detaching the frame cover and turning off the power. (See the

Sections D-1 & D-2 "Removing the Frame Covers.")

[1] Correction with Nuts of Workload Unit Reinforcing Metal Base

This correction is a minor correction method which allows

adjustment by the fastening force of the frame-side nuts of the

workload unit reinforcing metal base.

1. Check the contacting area by slowly rotating the copper disk

plate with your hands.

2. Adjust the two frame-side nuts of the workload unit reinforcing

metal base in the following procedures. (Fig. 1)

A. Loosen the nut on the workload unit side, and the nut on the

frame side (Fig. 1).

B. If the right side of the copper disk plate contacts the core,

when the main unit is viewed from the direction as depicted

in Fig. 3, fasten the frame-side nut.

C. Then, fasten the frame-side nut on the other side until the

copper disk plate comes close to the center of the core slit

(Fig. 2). [ Rotate the copper disk plate slowly, and check for

any contacts on the entire area of the plate.

D. Fasten the nuts which had been tightened in the above step

A.

[2] In case correction is not possible by the method stated in [1].

Replace the whole workload unit. (See the Section MS-2 "Replacing

the Workload Unit (w/ Flywheel).")

ES-4

Correcting the Position of Solenoid Coil

Workload Unit
Reinforcing Metal
Base

Solenoid Coil

EC-1200 & EC-1600

Workload Unit
Reinforcing
Metal Base

Solenoid Coil

EC-3600 & EC-3700

Fig. 1

Workload-Unit-
Side Nut

Frame-Side Nut

Fig. 2

Core Slit

Copper Disk Plate

Core

Correct Position

Solenoid Coil

Fig. 3

Core Slit

Copper Disk Plate

Core

Copper disk plate contacts the core.

Solenoid Coil

Correcting the Position of Solenoid Coil

Workload Unit Reinforcing
Metal Base

This manual is related to the following products: