CatEye EC-3600 - Manual (Page 25)

Cateye Ergociser Series 1000 Service Manual
23
EC-1200 EC-1600 EC-3600 EC-3700 Applicable Models:
D-2
D-2
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Removing the Frame Covers
Recumbent Type (EC-3600 & EC-3700)
When any repair or adjustment of parts within the frame is required,
remove the frame covers in the following procedures.
REMOVAL
1. Remove the pedals at both the left and right sides. (The right
side pedal can be removed by turning it in the clockwise
direction, and the left side pedal can be removed in the
counter-clockwise direction.) (Fig. 1)
2. Remove the crank cover fixing screws. The narrow-width area
of the crank cover should be positioned in between the frame
cover and the crank. (Fig. 2)
3. Remove the leg pipe fixing screws. (Fig. 3)
* You do not have to remove the leg pipe itself.
4. Remove the frame cover fixing screw with a screwdriver before
removing the frame cover. (Fig. 4)
ASSEMBLING
1. Place the frame covers onto the frame at both right and left
sides, paying attention to the position of the crank. At the
same time, the center cover should be built in.
2. Fix the right and left frame covers with frame cover fixing
screws.
3. Pass the crank through the hole on the crank cover, and fix the
crank cover onto the frame cover with screws. (Fig. 2)
4. Fix the front leg with casters with the leg pipe fixing screws.
5. Mount the pedals.
Pedal
Crank
No. 15 Wrench
Crank Cover
Front Leg with
Casters
R
Center Cover
Screw
Frame Cover
Removing the Frame Covers
Leg Pipe
Fixing Screw