Char-Broil 463271309 - Manual (Page 15)

Upper back panel
6
5
1/4-20x1½”
screw
7mm lock
washer
7mm flat
washer
15
On back of grill, place upper back panel between side panels and
above lower back panel. Secure upper back panel, in lower holes,
using one 1/4-20x1½” screw, 7mm lock washer, and 7mm flat
washer on each side. Do not fully tighten screws until side shelf
installation is complete in later steps.
Insert flange on right side shelf into side shelf brackets on side of firebox, shown A.
Attach rear of shelf using one 1/4-20x3/4” screw, 7mm lock washer, 7mm washer and 1/4”nut in upper hole; using one flat
1/4-20x1½” screw,7mm lock washer and 7mm flat washer in lower hole, shown B/C.
two Attach front of shelf and fascia using 1/4-20x3/4”
C/D/E.
screws, 7mm flat washers,
#8x3/8” self-tapping screw with large flat washer, shown
7mm lock washers and 1/4”nuts, and one
A
C
1/4-20x1½” screw
1/4-20x3/4” screw
7mm lock
washer
7mm lock
1/4”nut
1/4”nut
washer
7mm lock
washer
7mm flat
washer
7mm flat
washer
7mm flat
washer
1/4-20x3/4” screw
*Insert this screw from
the back of main control
D
#8x3/8” tapping
screw
large flat
washer
Front of Shelf
Rear of Shelf
Back of main control panel
1/4-20x3/4”
Igniter Switch
screw
7mm lock
washer
7mm flat
washer
1/4”nut
E
B
panel