Heli-Max HMXE0801 - Manual (Page 3)

SET UP QUICK REFERENCE
Please use this table as a reference while setting up the Axe 400 Rx-R. Please refer to your manufacturer’s transmitter
instructions to ensure that the model is set up correctly. Once the model is set up, verify that the controls operate as
described in the Heli-Max Axe 400 RTF manual.
*Leave the trim step set to 4 until the initial trim fl ight is completed. Then you can reduce the trim step to 1 for a fi ner
adjustment.
FINAL SET UP
Mount the receiver using double sided tape as shown below. Using a wire tie, bundle the wires and place them on top of the receiver.
This ensures that the wires cannot become entangled in the main rotor gear or the counter gear that drives the tail rotor.
Disconnect the main drive motor from the ESC. Turn your
transmitter on. Install a fl ight battery into the helicopter and
connect the battery to the ESC. Allow the gyro 5 seconds
to initialize.
Verify that you have disconnected the drive motor. Carefully
raise the throttle stick to the middle position. The servos,
blade grips and all the mixing levers should be perfectly
level. If necessary please make adjustments to the servo
arms, linkages or to the radio set up. Linkage lengths are
listed in the Heli-Max Axe 400 RTF manual.
3
Swashplate Type Futaba 6EX Futaba 7C Futaba 9C Futaba 10D Futaba 12 / 14
120° CCPM 3-S HR-3 HR-3 HR-3 HR-3
CCPM Elev
CCPM All Servo Servo Throttle Tail Rotor Gyro CCPM COL
Swash AFR Aileron +85% Elevator -85% COL +35%
EPA / ATV 100% / 100% 100% / 100% 100% / 100% 70% / 70% 100% / 100% 100% / 100%
D/R 100% H – 70% L 100% H – 70% L 100% H – 70% L
EXP -50% H – 35% L -50% H – 35% L -50% H – 35% L
Reverse
(Futaba Only) 1 – Reverse 2 – Normal 3 – Reverse 4 – Normal 5 – Normal 6 – Normal
Sub Trim 0 0 0 0 0 0
Trim Step* 4* -- 1 4* -- 1 4 4* -- 1
Fail Safe Low Throttle
GYRO Heading Hold
(Heading Hold) 45% Gain
HOV-THR INH - Best to use mechanical adjustments
HOV-PIT INH - Best to use mechanical adjustments
Throttle Hold ACT POS>+- 0% R-OF> INH RT>+- 0%
Throttle Curve
Normal 0% 32% 65% 82% 100%
Idle Up 1 100% 92% 85% 92% 100%
Pitch Curve
Normal 45% / -2° 47% 50% / 0° 75% 100% / +10°
Hold 30% / -4° 40% 50% / 0° 75% 100% / +10°
Idle Up 1 0% / -10° 25% 50% / 0° 75% 100% / +10°
Swash->
Throttle Mixing Idle Up Only Left/Right Cyclic 20% Forward/Aft Cyclic 20%