Haltech E6X Manual Win Version - Manual (Page 116)

E6X Manual
116
B.7.2 Alternate Ignition Systems
The output of the Haltech Ignition Module can be used to trigger after-market ignition
systems such as MSD or Jacobs. If an aftermarket ignition system such as MSD is to be used,
the Spark Edge must be set to Rising. The ignition system may still fire correctly if the Spark
Edge is set to Falling, but the ignition timing will incorrectly advance as RPM increases,
which can cause engine damage.
If you are using an aftermarket ignition system described above the setup page should appear
as follows:
Ignition Setup page showing aftermarket ignition Setup
When using the MSD 6A, connect the Ignition #1 wire to the white “Point input” wire.
Set
Rising
Edge
Set
Constant
Duty
Set
50%
Duty