Haltech E6X Manual Win Version - Manual (Page 110)

E6X Manual
110
4 Cylinder Ignition Toggle
The E6X does have the ability to run a 4-cylinder engine in sequential injection mode as well
as running two Waste Spark ignition outputs, by using the Ignition Toggle feature. This
feature can only be used on a four-cylinder engine, already in Sequential Injection mode.
To activate Ignition Toggle, you must firstly make sure that the Ignition Spark Mode is set to
Distributor, before changing the Injection Mode to Sequential. Once Distributor Spark mode
has been set, activate the Ignition Toggle feature by checking the “Internal Toggle On”
check box in the Setup->Igniton Setup page.
Figure B6. Ignition Setup page showing Ignition Toggle Setup
Below is the allocation of Injection/ Ignition outputs when Ignition Toggle is activated.
ECU Output Connection / Function
INJ1 Injection Output for 1 st cylinder to fire
INJ2 Injection Output for 2 nd cylinder to fire
INJ3 Injection Output for 3 rd cylinder to fire
INJ4 Injection Output for 4 th cylinder to fire
Ignition # 1 Ignition Output for Coil 1 (Connected via ignition module)
Ignition # 2 Ignition Output for Coil 2 (Connected via ignition module)
Ignition # 3 Not available for use with this configuration.
Ignition # 4 Not available for use with this configuration.
Internal
Toggle On
Distributor
Mode Set