Haltech E6X Manual DOS Version - Manual (Page 52)

E6X Manual
52
Never This causes the ECU to only use the primary base fuel and
ignition maps.
Always This causes the ECU to only use the secondary base fuel
and ignition maps.
Enable with Aux. In This causes the ECU to use the primary base fuel and
ignition maps when the Aux. In is not connected to ground.
The ECU uses the secondary base fuel and ignition maps
when the Aux. In is connected to ground.
Note:
The Aux. In field in the Input/Output Set-up page must be set to Dual Maps
Input. Refer to 4.2.4 The In/Out Set-up Page, p49
Enable with VTECH
This causes the ECU to use the primary base fuel and
ignition maps when the VTECH Output is inactive. The
ECU uses the secondary base fuel and ignition maps when
the VTECH Output is active.
Use of Gas Compensation Maps
This field tells the ECU how to use the gas compensation maps.
Note:
The gas compensation maps can only be used if the spare A/D and the Trim
input are configured for gas pressure and gas temperature. Refer to 4.2.4 The
In/Out Set-up Page, p49.
The options are:
Always
The gas compensation maps will always be used.
Enable with Aux. In The gas compensation maps will only be used if the Aux.
In. line is connected to ground. The gas compensation
maps will not be used if the Aux. In. line is not connected
to ground.