Haltech E6X Manual DOS Version - Manual (Page 23)

E6X Manual
23
To run the Install program type:
! ! ! !
INSTALL and then press the Enter Key.
The Install program will now run. Follow the instructions given. When it is finished, the
installation program will tell you if the installation is successful. If it was not, consult the
trouble shooting section of this manual in the Appendix.
The Programming software is now ready to run.
2.2.2 Running the Software from the Hard Disk
Start you computer, at the MS-DOS prompt (C:\>) type:
CD \HALTECH and then press the Enter Key.
Your should then see an MS-DOS prompt that appears as:
C:\HALTECH>
Then type:
CD \E6X
At this prompt type:
E6X and then press the Enter Key.
2.2.3 Running the Software from the Floppy Disk
If you have installed the software as described previously you can skip ahead to 2.2.4 Azerty
Keyboards in MS-DOS, p23.
To run the software from a floppy drive, start your computer, when the MS-DOS prompt
appears:
A:\>
Insert the Programming disk in the disk drive, to start the E6X program type:
E6X then press the Enter Key.
The programming software will now run.
2.2.4 Azerty Keyboards in MS-DOS
Most countries use a keyboard where the first six letter keys across the top row are:
“QWERTY”
This is called a “Qwerty” keyboard. Some countries use an alternative, which is called an
“Azerty” keyboard, where the Q and W keys are swapped with the A and Z keys respectively.
If you have an Azerty keyboard, you need to start the software differently. When you would
normally type: