Haltech E6X Manual DOS Version - Manual (Page 38)

E6X Manual
38
3.1.3 The Set-up Menu
The set-up menu allows access to the ECU set-up pages (which contain most of the
information about the engine that the ECU is to control) and the program set-up page.
The set-up menu contains:
- Main Set-up CTRL-M
- Fuel Set-up
- Ignition Set-up CTRL-G
- In/Out Set-up CTRL-N
- Program Set-up CTRL-P
- Dual Map Set-up
- Switch Mode CTRL-S
- Calibrate Throttle
The contents of the set-up pages and the usage of “Switch Mode” and “Calibrate Throttle” are
described in CHAPTER 4 Configuring the ECU, p42
3.1.4 The Options Menu
The options menu allows access to the option pages. The options set-up pages allow the user
to modify the setting for idle control, closed loop O2 Control and the 4 PWM channels and
any available digital outputs.
The options menu contains:
- Engine Data Page
-
Engine Data Set-up Page
- Output Options
- PWM Options
- Throttle Pump
- Data-log
-
Injector trims
- Print ECU Information
Further description of the contents of the options menu is distributed throughout the manual.
3.2 Online and Offline Operation
The programming software can be used in two ways: “Online” and “Offline”. In the Online
mode, all the changes made to the maps and set-up data in the software will be transmitted to
the ECU. This is what is called online programming and it is in this mode that most tuning is
carried out. In the offline mode, making changes to the maps and set-up data will not affect
the ECU since communication between the programming PC and the ECU is not active.
Working in the offline mode is a convenient way of checking maps that have been stored to
disk and reviewing Data-logs that were taken when in the Online mode.