beautypg.com

Ama safety code, Preflight, Radio control general – Great Planes Spirit 100 ARF - GPMA1049 User Manual

Page 17: Range check, Charge the batteries identify your model, Balance the model laterally

background image

1. With the wing level, have an assistant help you lift the

model by the tip of the fuse and the bottom of the fin. Do this
several times.

2. If one wing always drops when you lift the model, it means

that side is heavy. Balance the airplane by adding weight to the
other wing tip. An airplane that has been laterally balanced
will track better in loops and other maneuvers.

No matter if you fly at an AMA sanctioned R/C club site or if you
fly somewhere on your own, you should always have your
name, address, telephone number and AMA number on or
inside your model. It is required at all AMA R/C club flying sites
and AMA sanctioned flying events. Fill out the identification tag
on the decal sheet and place it on or inside your model.

Follow the battery charging instructions that came with
your radio control system to charge the batteries. You
should always charge your transmitter and receiver batteries
the night before you go flying, and at other times as
recommended by the radio manufacturer.

Ground check the operational range of your radio before the
first flight of the day. With the transmitter antenna collapsed
and the receiver and transmitter on, you should be able to walk
at least 100 feet away from the model and still have control.
Have an assistant stand by your model and, while you work the
controls, tell you what the control surfaces are doing. If the
control surfaces do not respond correctly, do not fly! Find and
correct the problem first. Look for loose servo connections or
broken wires, corroded wires on old servo connectors, poor
solder joints in your battery pack or a defective cell, or a
damaged receiver crystal from a previous crash.

Read and abide by the following excerpts from the Academy
of Model Aeronautics Safety Code. For the complete Safety
Code refer to

Model Aviation magazine, the AMA web site or

the Code that came with your AMA license.

1) I will not fly my model aircraft in sanctioned events, air shows,

or model flying demonstrations until it has been proven to be
airworthy by having been previously, successfully flight tested.

2) I will not fly my model aircraft higher than approximately

400 feet within 3 miles of an airport without notifying the
airport operator. I will give right-of-way and avoid flying in
the proximity of full-scale aircraft. Where necessary, an
observer shall be utilized to supervise flying to avoid
having models fly in the proximity of full-scale aircraft.

3) Where established, I will abide by the safety rules for the

flying site I use, and I will not willfully and deliberately fly my
models in a careless, reckless and/or dangerous manner.

5) I will not fly my model unless it is identified with my name

and address or AMA number, on or in the model. Note:
This does not apply to models while being flown indoors.

7) I will not operate models with pyrotechnics (any device

that explodes, burns, or propels a projectile of any kind).

1) I will have completed a successful radio equipment ground

check before the first flight of a new or repaired model.

2) I will not fly my model aircraft in the presence of

spectators until I become a qualified flier, unless assisted
by an experienced helper.

3) At all flying sites a straight or curved line(s) must be

established in front of which all flying takes place with the
other side for spectators. Only personnel involved with
flying the aircraft are allowed at or in the front of the flight
line. Intentional flying behind the flight line is prohibited.

4) I will operate my model using only radio control

frequencies currently allowed by the Federal
Communications Commission.

5) I will not knowingly operate my model within three

miles of any pre-existing flying site except in
accordance with the frequency sharing agreement
listed
[in the complete AMA Safety Code].

Radio Control

General

AMA SAFETY CODE (

EXCERPTS

)

Range Check

CAUTION: Unless the instructions that came with your
radio system state differently, the initial charge on new
transmitter and receiver batteries should be done for 15
hours using the slow-charger that came with the radio
system
. This will “condition” the batteries so that the next
charge may be done using the fast-charger of your choice.
If the initial charge is done with a fast-charger, the
batteries may not reach their full capacity and you may be
flying with batteries that are only partially charged.

Charge the Batteries

Identify Your Model

PREFLIGHT

Balance the Model Laterally

17