Great Planes P-51 Mustang Sport Fighter .46 EP ARF - GPMA1208 - Manual (Page 7)

7
❏
14. Tape the wings together and allow the glue to harden.
❏
15. Install a Y-harness to the two aileron servo leads.
Secure the leads with shrink tube or tape.
❏
16. Assemble the pushrod components as shown. Place
the control horn on the aileron in line with the servo arm. Drill a
1/16" [1.6mm] hole though the surface of the aileron. DO NOT
DRILL THROUGH THE TOP OF THE AILERON! Secure the
control horn with two 1/16" x 3/8" [2x10mm] screws. Drill a
5/64 [2mm] hole in the outer hole of the servo arm. Install the
clevis to the outer hole of the control horn. Center the aileron
and the servo. Make a mark on the wire where it aligns with
the servo arm outer hole. Bend the wire on the mark. Secure
the wire to the servo arm with a Faslink and then cut off the
excess length of wire.
Hinge Line Hinge Line
CORRECT INCORRECT
H
FasLink
2-56 (.074") Pushrod Wire
Servo Horn
1/16"
❏
17. Repeat this for the other aileron servo.
❏
18. Temporarily mount the wing to the fuselage with two
10-24 x 2" [51mm] nylon bolts.