Great Planes P-51 Mustang Sport Fighter .46 EP ARF - GPMA1208 User Manual
Page 13
13
❏
9. Install the tail wheel, securing it with the wheel collar
and set screw.
❏
10. Install a clevis and clevis keeper onto two 20" [508mm]
pushrod wires. Insert the wires into the holes in each side
of the fuselage. Attach the clevis to the outer hole of each
control horn. Slide the clevis keeper over the clevis.
❏
11. As you did with the ailerons, drill 1/16" [1.6mm] holes
for mounting each servo. Secure each servo with four servo
screws. Drill a 5/64" [2mm] hole in the outer hole of the
servo arm. Center servos, rudder, and elevator, then make
a mark on the wire where it aligns with the servo arm outer
hole. Bend the wire on the mark. Secure the wire to the servo
arm with a Faslink and then cut off the excess length of wire.
Note: If you are installing a glow engine continue with step
12. If you will be using electric power skip ahead to page 14.
❏
12. If you are installing a glow engine, install the throttle
servo the same as you did the elevator and rudder servos.
❏
13. As you did with the other servos, drill 1/16" [1.6mm]
holes for mounting each servo. Secure the servos with four
servo screws. Drill a 5/64" [2mm] hole in the outer hole of the
servo arm. You will complete the throttle servo installation
during the engine installation. Skip ahead to the ENGINE
INSTALLATION on page 16.