Great Planes P-51 Mustang Sport Fighter .46 EP ARF - GPMA1208 - Manual (Page 5)

5
IMPORTANT BUILDING NOTES
● Throughout the manual you will be told to drill holes into
the wood and insert the screws. In all cases you should
insert the screw and then remove the screw. Apply a drop of
thin CA glue to harden the threads. After the glue hardens
re-install the screws.
● When installing nuts on screws and bolts be sure to apply
a drop of thread locker to each one.
● Whenever the term glue is written you should rely upon
your experience to decide what type of glue to use. When
a specifi c type of adhesive works best for that step, the
instructions will make a recommendation.
● The canopy/hatch is pre-installed on the fuselage. To
remove it, slide the canopy forward and lift it from the rear.
ASSEMBLE THE WING
❏
1. Tighten the covering.
❏ ❏
2. Remove the end of the string from the wing. Do not
pull the string completely out of the wing.
❏ ❏
3. Install servo arm and hardware. Tie string to the
servo lead.
❏ ❏
4. The end of the string is taped to the root rib of the
wing. Pull servo lead through the wing.
❏ ❏
5. Pull the servo lead through the hole in the wing.