Globalstar SmartOne - Manual (Page 43)

SmartOne Manual Rev 1.4 DOC# 9100-0268-01 p.43
Input Settings Tab
Status Changed Message. The SMARTONE has two inputs that can be
configured to send a Status Changed Message once the selected input
opens, closes, or in both events. The Message sent can or can not
contain the GPS coordinates of the device at the time the status of the
input (s) changed. The SMARTONE can also send this message when it enters or
exits the Vibration State.
Undesired State Message. The SMARTONE can be configured to send messages
throughout the time the input in the desired state message, either to
opened or closed position. The message interval while the input is
active can be configured in Days, Hours, and Minutes. Once the input is
de-activated, the
SMARTONE will return to the message interval or time
(s) of day for Location Messages. The SMARTONE can also be configured to send
messages throughout the time the device is in the State of Vibration.
Accumulate/Count Message. The SMARTONE can accumulate hours and events
while input 1 or input 2 is enabled. The
SMARTONE can send an
accumulate/count message once the configurable number of hours or events