Globalstar SmartOne - Manual (Page 31)

SmartOne Manual Rev 1.4 DOC# 9100-0268-01 p.31
Status Changed Message. The SMARTONE has two inputs that can be
configured to send a Status Changed Message once the selected input
opens, closes, or in both events. The Message sent can or cannot contain
the GPS coordinates of the device at the time the status of the input
(s) changed. The SMARTONE can also send this message when it enters or exits
the Vibration State.
Undesired State Message. The SMARTONE can be configured to send messages
throughout the time the input is the desired state, either to opened or
closed position. The message interval while the input is active can be
configured in Days, Hours, and Minutes. Once the input is de-activated,
the
SMARTONE will return to the message interval or time (s) of day for
Location Messages. The SMARTONE can also be configured to send messages
throughout the time the device is in the State of Vibration.
Accumulate/Count Message: The SMARTONE can accumulate hours and events
while input 1 or input 2 is enabled. The
SMARTONE can send an
accumulate/count message once the configurable number of hours or events
have been reached. In addition, The
SMARTONE can send the actual value
of accumulated hours and events at configurable intervals specified in
days, hours, and minutes. If Times of Day is selected, user will specify the
times in the Location Message Tab.