Galaxy Audio POWERED MICRO SPOT - Manual (Page 10)

Page 9
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF FIRE OR ELECTRICAL
SHOCK,DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
AVIS:
RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
C RE PA5 140 O X
1 2 3 4 02 03 04 05 12 11 10 9 8 7 6 5
SPEAKER OUTPUT
73W 8ohms Min.
60HZ 250W 120V ~
50HZ 250W 230V ~
LINE OUT
SERIAL NO.
93FL
COMMERCIAL
AUDIO EQUIPMENT
601 E. Pawnee Wichita, KS 67211
316.263.2852 www.galaxyaudio.com
7
7
G A L A X Y A U D I O
SPEAKER OUTPUT
1/4” connector output from the internal amplifier.
It can supply an external 8 ohm speaker with 73
watts of RMS power. This means two 16 ohm
HOT SPOTS can be connected to the system
without overloading the amplifier; great for a small
PA or monitor setup.
LINE OUT
RCA jack -10dB line level output
can be fed to a recorder, or to other
sound system components. It is
post-EQ, pre-compressor and
pre-amplifier.
CONNECTORS/INDICATORS and their operation
(Rear Panel)
POWER CORD
Effects devices for microphones or a second instrument may be fed
into one input while an instrument, CD player or tape deck is
fed into the other.
POWER SWITCH
TONE CONTROLS
When all three controls are set to
the 12 o’clock (detent) position,
the output frequency response is flat.
MIC (XLR) INPUT
Balanced input with 24 VDC
phantom power for electret
microphones.
POWER LED
LIMIT LED
Indicates when the built-in compression circuit is activated. By automatically reducing gain before clipping occurs the
compression circuit prevents distortion. The LIMIT LED remains lit about half the time when the amplifier is being driven
to its maximum potential. Do not allow it to remain lit more than half the time.
HIGH +/- 12dB shelving at 15 kHz
MID +/- 10dB peak/dip at 2 kHz
LOW +/- 10dB peak/dip at 300 Hz
The PA5X (POWERED HOT SPOT)
CONTROLS/INDICATORS and their operation (Front Panel)
D
LEVEL CONTROL FOR MIC (XLR) INPUT
LEVEL CONTROL FOR 1/4" INPUT
1/4" INPUT