Galaxy Audio DS-CP25 User Manual
Page 16
15
HPF sub-menu - from this sub-menu, it is possible to set the Input Channels High Pass Filter (HPF),
preceding the bank of 5 Peaking/Shelving filters.
The following is an example of a HPF sub-menu screen with the filter set at 24dB Linkwitz/Riley on Channel
A/Left:
The filter’s parameters can be modified by use the “PM2” and “PM3” encoders for editing the Filter’s Low
Cut Frequency and the Filter’s Type and Order.
The Low Cut Frequency of the High Pass Filter can be edited using the
encoder and the Filter’s
“PM2”
Type and Order can be edited by using the
encoder.
“PM3”
“Low
Cut Frequency” - the selectable frequencies range is from 20Hz to 20kHz in steps of 1/12 of an
Octave and can be adjusted by rotating the
encoder.
“PM2”
“High Pass Type and Order” - allows you to select the EQ’s High Pass Filter Shape and Order.
The available shapes and orders for the High Pass Filter, that are accessible by rotating the “PM3” encoder,
are listed below:
- No Cut-Off (High Pass Filter Bypassed)
- Butwrth 6dB (Butterworth Filter 6dB/Oct Slope)
- Butwrth 12dB (Butterworth Filter 12dB/Oct Slope)
- Lnk/Ril 12dB (Linkwitz/Riley Filter 12dB/Oct Slope)
- Bessel 12dB (Bessel Filter 12dB/Oct Slope)
- Butwrth 18dB (Butterworth Filter 18dB/Oct Slope)
- Butwrth 24dB (Butterworth Filter 24dB/Oct Slope)
- Lnk/Ril 24dB (Linkwitz/Riley Filter 24dB/Oct Slope)
- Bessel 24dB (Bessel Filter 24dB/Oct Slope)
Note1: Once the desired options have been selected using the 2 encoders, they are automatically saved as
current and stored in the DS-CP25 system status once leaving the page.
Note2: To exit this page, push the
button.
“ESC”
LPF sub-menu - from this sub-menu it is possible to set the Input Channels Low Pass Filter (LPF),
following the bank of 5 Peaking/Shelving filters.
The following is an example of a LPF sub-menu screen with the filter set at 24dB Linkwitz/Riley on Channel
A/Left:
The filter’s parameters can be modified by use the “PM2” and “PM3” encoders for editing the Filter’s High
Cut Frequency and the Filter’s Type and Order.
The High Cut Frequency of the Low Pass Filter can be edited using the “PM2” encoder and the Filter’s
Type and Order can be edited by using the
encoder.
“PM3”
“High
Cut Frequency” - the selectable frequencies range is from 20Hz to 20kHz in steps of 1/24 of an
Octave and can be adjusted by rotating the
encoder.
“PM2”
“Low
Pass Type and Order” - this page allows you to select the Eq’s Low Pass Filter Shape and Order.
OutputA Left HPF
-> 40.0 Hz Lnk/Ril 24dB
OutputA Left LPF
-> 12.0 kHz Lnk/Ril 24dB