Philips VR237 - Manual (Page 6)

Safety instructions
The manufacturer cannot be held responsible for
any damage which is incurred by not using the video
recorder in compliance with the national guarantee
conditions and safety regulations.
First check that the supply voltage indicated on the
back of your video recorder is the same as your local
supply voltage.
Danger - high voltage in this appliance! Do not open!
The video recorder does not contain any parts that
can be repaired by the user. As long as your video
recorder is connected to the mains there are parts of
it still in operation. To switch off the video recorder
completely you must disconnect it from the mains.
Ensure that air can circulate freely through the
ventilation slots of your video recorder. Do not place
your video recorder on soft surfaces.
Protect your video recorder from rain and damp.
Ensure that no objects or liquids enter the
equipment. If liquid is spilt into the video recorder,
disconnect the video recorder from the mains
immediately and call the After-Sales Service for
advice.
Do not place your video recorder close to a source of
heat (radiator etc).
Precautions
The video recorder should not be used immediately
after transportation from a cold to a hot area or vice
versa, or in conditions of extreme humidity.
After unpacking your video recorder, it should be
allowed to acclimatize for at least three hours before
installation.
£3