Philips VR6293 - Manual (Page 10)

0 Press SEARCH.
The video recorder searches for a TV station.
The Dispiay shows for exampie:
Tl l l ~
I
_iO
l!_i
• When a TV station is found, it appears on the TV.
The Display shows for example;
c T n o r
_l * U l ' u
^ c n
C u u
\ /
u ^
1
/ \
• If the picture quality on the TV is poor, press SEARCH again.
• If you want to cancel the search, press |(i) orl.
• Through interferences in some cable TV networks, it may
happen that the search run skips a TV channel.
If this happens, this TV channel can be selected like mentioned in
chapter "Direct channel storage".
(5) Select the desired preselection number using + or - or the
digit buttons on the remote control.
To change the number slowly, press + or - repeatedly.
To change the number quickly, press and hold + or -.
Select the same preselection numbers for the TV stations on the
video recorder as those on your TV.
(6) Press STORE.
(7) Repeat steps 0 to (6) for all the TV stations.
General notes:
- After you have stored all TV stations, you can use + or -
or the digit buttons (0-9} to select these TV stations.
- if you store a TV station on a number that has already
been used, the new station wiil be stored, and the old TV station
will be deleted.
DIRECT RECORDING
6
Have y o u fo llo w ed th e In structio n s In the chapters ‘Installatio n ’
an d 'S to ring TV statio n s’?
If so, proceed w ith th is ch ap ter.
You do not need to switch on the TV. However, if it is on, you can
change to another TV station on your TV without interfering with
the TV programme being recorded.
If you want to watch the TV programme to be recorded, switch
on the TV and select the preselection number for the video
recorder.
Checking or changing the tape iength indication
• Press ((7D).
A tape length indication (e.g. E30 = 30 minutes - E 300 = 300
minutes) is shown on the Display.
CASSETTE
V i 1 I 1 1 X
- 7R4/;5W/T-
•'II 1 1 »
Lli- lU
If the tape length shown is not the same as the tape length of the
cassette to be loaded:
• Press + or - to change the tape length in the following
sequence: E30, E60, E90, E105, E120, El 50, E180, E 195, E210,
E240, E300, EC30, E30, ect.
• Press (IttO) on the remote control. If the transmission is
accepted the Display of the video recoder shows, for example:
T O O C
I Ml (_
CZii-in
!_!_ lU
Notes:
— The used time or time left display will only be correct if
you have selected a tape length which is the same as the
actual length of the cassette to be loaded.
— After you have selected the tape length, or you have
loaded a new cassette, the used time and time left display
initially shows;-.-. Then after a few seconds of tape
movement the correct times are shown on the display.
6 (g)