Philips FW560C - Manual (Page 25)

RECORDING MAINTENANCE
Recording from other sources (only on tape
deck 11_____________________________________________________
1 Load a blank tape into tape deck 1.
2 Press CD, TUNER or AUX
• Start playback of the selected source.
3 Press RECORD on tape deck 1 to start recording.
—■ The REC flag is flashing.
4 Press PAUSE to interrupt recording.
5 Press STOP «OPEN on tape deck 1 to stop recording.
Note:
- During recording, it is not possible to listen to another
sound source.
CD Synchro Start Recording_______________
During CD synchro start recording;
• It it not advisable to fast forward/rewind your tape in
tape deck 2.
• It is not possible to listen to another sound source.
1 Load a blank tape into tape deck 1 and a disc into the
disc tray.
2 Select CD and start playback.
• You can program the tracks in the order you want them
to be recorded (see Programming Tracks). If not, the
tracks are recorded according to the selected disc.
3 Press RECORD on tape deck 1 to start recording.
-* The REC flag is flashing.
4 Press PAUSE to interrupt recording.
5 Press STOP »OPEN on tape deck 1 to stop recording
and STOP ■ to stop CD playback.
Dubbing tapes (from tape deck 2 to tape deck II Maintenance
1 Load the prerecorded tape into tape deck 2 and a
blank tape into tape deckl.
Make sure that both tapes have their full spool to
the left.
2 Press DUBBING to switch between normal and high
speed dubbing.
"tJuRi'IRL" (normal speed) or TR5T" (high speed)
will be displayed.
The HSD flag appears on the display for high speed
dubbing.
3 Press PAUSE on tape deck 1.
4 Press RECORD on tape deck 1.
5 Press PLAY ► on tape deck 2.
Recording will start automatically.
The REC flag starts flashing.
6 Press STOP »OPEN on tape deck 1 and 2 to stop
dubbing.
Notes:
- At the end of side A, flip the tapes to side B and
repeat the procedure.
- Dubbing of tapes is only possible from tape deck 2 to
tape deck 1.
- To ensure good dubbing, use tapes of the same length.
- During high speed dubbing in Tape mode, the sound is
reduced to a low volume.
Cleaning the Cabinet
• Use a soft cloth slightly moistened with a mild
detergent solution. Do not use a solution containing
alcohof, spirits, ammonia or abrasives.
Cleaning Discs
• When a disc becomes dirty, clean it with a cleaning
cloth. Wipe the disc from the center out.
• Do not use solvents such as benzine, thinner,
commercially available cleaners, or antistatic spray
intended for analog records.
Cleaning the CD lens
• After prolonged usage, dirt of dust may accumulate at
the CD lens. To ensure good playback quality, clean
the CD lens with Philips CD Lens Cleaner or any
commercially available. Follow the instructions
supplied with the Lens Cleaner.
Cleaning the Heads and the Tape Paths
• To ensure good recording and playback quality, clean
the heads, capstan(s) and pressure roller(s) after every
50 hours of tape operation.
• Use a cotton swab slightly moistened with cleaning
fluid or alcohol.
• You can also clean the heads by playing a cleaning
tape through once.
Demagnetizing the heads
• Use a demagnetizing tape available at your dealer.
25