Futaba 9VAP - Manual (Page 48)

ADJUSTMENTS AND FLIGHT TECHNIQUES
•MODEL COPY FUNCTION
•The Copy function allows the programmed data and trim positions for one model to be duplicated in
their entirety on another program (model) number. As an example, let's suppose that Aircraft No. 1 is
properly-trimmed and f l y s well, but you wish to experiment with a different mixing or trim setting. The
Model No. 1 data can be copied onto the Model No. 2 program. You can then make the experimental trim
modification on the Model No. 2 program only. The original settings will be retained as is, on the No. 1
program. The MODEL SELECT function can then be used to easily switch back and forth between the
old and new setting for comparison (although not in-flight).
• As another alternative, settings for a given model could be copied on two or more programs with modifi-
cations for different weather conditions, maneuver schedules, etc.
Setting Method
1) Perform the Model Select function to select
the Model No. that you wish to copy.
2) Move the cursor to the program No. that you
wish to copy the data onto, and press the
program key.
3) A message will appear asking if the data is to
be copied, (in the example shown, the Model
No. 1 data is to be copied to the Model No. 2
program slot.)
4) Press the key to execute the copy func-
key to cancel.
NOTE: Perform the TRIM MEMORY function
before copying. The trim levers can then be set
to the neutral position.