Futaba 4PKS-R 2.4GHz - Manual (Page 82)

Warning display
82
Fu
n
c
tio
n
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* W h e n t h e d ire c t c all but to n
is set, the setup screen is also
called by the following method:
This is a function select switch function. The idle-up function ON/OFF switch must be
set. (p.96)
It is used to improve engine starting performance by raising the idling speed when the
engine of a gasoline car (boat) is started.
This function is also effective when you want to prevent braking when the power was
turned off during running due to the effect of gear ratio setting and the motor used
with a motor car. However, when using the MC960CR, MC950CR, MC851C, MC602C,
MC402CR, etc., check the ESC neutral position and set the idling function switch to ON
after the set enters the operation mode, the same as the neutral brake function (p.80).
The throttle neutral position is offset to the forward side or brake side. There is no link-
age locking, etc. because there is no change near the maximum operation angle even
when the neutral position is offset by this function.
Operation
)DLE
5P
)DLE
5P
0REPARATION
1
)DLE
5P
5SE
2
When ending setting, return to the initial screen by pressing
THE
Idle-Up function adjustment
FUNCTION
FUNCTION
)DLE
5P
(Throttle system)
Adjust button
TONS
PRESSING
Idle-Up rate (RATE)
$
If the power switch is turned on
while the idle-up switch is on, an
audible alarm will be heard. Im-
mediately set the Idle-Up switch
to OFF.
While this function is ON, the LED blinks. (When LED
is active)
also appears on the initial screen and menu
screen.
Operation Display