Flyzone HCAA23 - Manual (Page 6)

❏ 6. Unplug the battery pack from the charger and the
charger from the 12-volt power outlet in your vehicle.
❏ 7. After each flight, remove the pack from the airplane
and allow it to cool completely before recharging.
❏ 1. Always remove the battery from your Cessna 182
Skylane before charging.
❏ 2. Remember to check the temperature of the
battery every 5 minutes during charging. If the battery
becomes hot, unplug the battery from the charger,
even if the charger has not stopped charging.
❏ 3. Charging the Cessna 182 Skylane battery while
your car is running can be dangerous, because it
increases the chances of overcharging. For this reason,
you should never charge your Cessna 182 Skylane
battery while your car’s engine is running.
❏ 4. If you use a different peak battery charger, charge
this battery pack only at a maximum charge rate of 1
amp. A higher charge rate will charge the battery pack
too quickly and heat up the wires.
❏ 5. A properly cared for battery pack will last a long
time. If the battery pack is continually charged while it
is still hot or charged at too high of a rate, the life of the
battery pack will be shortened. WARNING: Misuse or
malfunction may overheat the battery and charger,
resulting in personal injury or damage to surroundings.
ATTENTION: The product you have purchased is
powered by a rechargeable battery. At
the end of the battery’s useful life, under
various state and local laws, it may be
illegal to dispose of this battery into the
municipal waste system. Check with
your local solid waste officials for details in your area
for recycling options or proper disposal. WARNING:
This product contains a chemical known to the State
of California to cause cancer.
❏ 1. The receiver is secured to the fuselage with hook
and loop material. Pull the receiver free and plug the
aileron servo lead into Channel “1” with the white
wire facing up (the channels are numbered on the
bottom of the receiver). Push the receiver back onto
the hook material.
❏ 2. At the front edge of the wing are two small posts.
Position the wing on the top of the fuselage and slide
the wing forward, inserting the posts in the holes on
the fuselage. Fasten the wing to the fuselage with the
large screw. The screw should be tight enough to
hold the wing snug against the fuselage, yet not crush
the wing. Do not over-tighten.
INSTALL THE WING
BATTERY RECYCLING
BATTERY CHARGING PRECAUTIONS
6
x 1
ACTUAL SIZE