Cisco OL-8131-01 - Manual (Page 18)

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Using Cisco Unified IP Phones with Different Protocols
2-18
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SIP), Cisco Unified IP Phones
OL-8131-01
Converting a New Phone from SCCP to SIP
A new, unused phone is set for SCCP by default. To convert this phone to SIP,
perform these steps:
Procedure
Step 1 Take one of these actions:
• To auto-register the phone, set the Auto Registration Phone Protocol
parameter in Cisco Unified CallManager Administration to SIP.
• To provision the phone using the Bulk Administration Tool (BAT), choose the
appropriate phone and choose SIP from the BAT.
• To provision the phone manually, make the appropriate changes for SIP on
the Phone Configuration page in Cisco Unified CallManager Administration.
Refer to Cisco Unified CallManager Administration Guide for detailed
information about Cisco Unified CallManager configuration. Refer to Cisco
Unified CallManager Bulk Administration Guide for detailed information about
using the BAT.
Step 2 If you are not using DHCP in your network, configure the network parameters for
the phone.
See the “Configuring Startup Network Settings” section on page 3-14.
Step 3 Power cycle the phone.
Converting an In-Use Phone from SCCP to SIP
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use
in your network from SCCP to SIP. To access BAT from Cisco Unified
CallManager Administration, choose Bulk Administration > Phones > Migrate
Phones > SCCP to SIP. For detailed information, refer to the “Migrating Phones”
chapter
in the Cisco Unified CallManager Bulk Administration Guide.