Die-cut layout – Dynaflite DYFA3901 User Manual
Page 7
NOTES ON REMOVAL OF DIE CUT PARTS FROM THE SHEET
1. Sand both sides of all die cut sheets enough to remove loose wood Fibers.
2. Bend each sheet slightly, along the direction of the grain, to identify the
side that is not cut completely through.
3. Sand this side until most of the parts can be easily removed from the sheet.
4. If a part is difficult to remove, use a sharp hobby knife to cut any
slivers of wood that are holding it in place.
7
Die-Cut Layout
INNER
PANEL
GUSSETS
OUTER
PANEL
GUSSETS