Dynaflite DYFA3901 - Manual (Page 4)

Hobby Knife (HCARO 105)
#11 Blades
Pliers (Common and Needle Nose)
Screw driver (Phillips)
T-pins(HCAQ5150)
60" Retractable Tape Measure (HCAR0478)
Straightedge With Scale
Masking Tape (TOPR8018)
Sandpaper (coarse, medium, fine grit)
Easy-Touch™ Bar Sander (or similar)
Plan Protector (GPMR6167)
Lightweight Balsa Filler such as Hobbico®
HobbyLite™ (Hobbico HCAR3400)
IsopropyI Rubbing Alcohol (70%)
Ballpoint Pen
90° Building Square
Heavy Sewing Thread (any color)
#64 Rubber Bands
Drill bits: 1/16", 5/64", 3/32", and 3/16"
Great Planes Easy-Touch Bar Sanders are made
from lightweight extruded aluminum and can be
found at most hobby shops. They are available in
five sizes - 5-1/2" (GPMR6169) for those tight,
hard to reach spots; 11" (GPMR6170) for most
general purpose sanding; and 22" (GPMR6172),
33" (GPMR6174) and 44" (GPMR6176) for long
surfaces such as wing leading edges. Easy-Touch
Adhesive-Backed Sandpaper comes in 2" x 12"
rolls of 80-grit (GPMR6180), 150-grit (GPMR6183)
and 220-grit (GPMR6185) and an assortment of 5-
1/2" long strips (GPMR6189) for the short bar
sander. The adhesive-backed sandpaper is easy to
apply and remove from your sanding bar when it's
time for replacement.
Custom sanding blocks can be made from balsa or
hardwood blocks and dowels for sanding difficult to
reach spots.
SUGGESTED BUILDING
SUPPLIES, CON'T.
OPTIONAL BUILDING
SUPPLIES
CA Applicator Tips (HCAR3780)
Epoxy Brushes (GPMR8060)
Epoxy Mixing Sticks (GPMR8055)
CA Debonder (GPMR6039)
Hot Sock™ (TOPR2175)
Single Edge Razor Blades (HCAR0312)
Heat Gun (TOPR2000)
Razor Plane (Master Airscrew®)
• When you see the term "test fit" in the
instructions, it means you should first position
the part on the assembly without using any
glue and then slightly modify or sand the part
as necessary for the best fit.
4