Dynaflite GPMA0525 - Manual (Page 24)

according to the instructions in this manual. After
your model is
C.G.’d correctly and ready to fly,
take it out to your flying field. Turn your
transmitter and receiver on and toss your Talon at
a level attitude straight into the wind. Try to keep
it on a straight glide path with the wings level as
it descends to the ground.
How did you do? If
your Talon climbed rapidly and caught a ten
minute thermal, well then what are you reading
this for? However, if your Talon climbed rapidly,
abruptly stalled, then landed, it may be tail heavy
or may require some down elevator trim. If your
Talon assumed a short glide path directly to the
ground, it may be too nose heavy or require
some up elevator trim. Adjust your elevator trim
accordingly and try again. If you cannot establish
a gentile glide path by adjusting the trims,
remove the wing and relocate your receiver
and/or battery pack in order to shift the C.G. as
required. Make changes to the C.G. in small
increments of no more than 1/8" or less.
Once you have your Talon trimmed and the C.G.
is set, you’re ready for the slopes!
C
L
5-3/4"
5/16"
DIHEDRAL BRACE TEMPLATE
THIS MODEL BELONGS TO:
NAME________________________
ADDRESS ____________________
CITY_________________________
STATE_______ZIP _____________
PHONE # _____________________
AMA # / SFA # _______________
Fill in the necessary information, then cut out this placard
and place it inside of your model.