Chief Manufacturing CTA-100 - Manual (Page 6)

Installation Instructions CTA-100
6
STEP 2
Figure 4. Install Pads on Adjustment Plates
Figure 5. Install Adjustment Plates
Installing Pads on Adjustment Plates
Install foam pads on adjustment plates, as follows:
1. Locate two foam pads (50) and two adjustment
plates (40). See Figure 4.
2. Remove protective tape from foam pad (50) to
expose the bond side.
3. Install foam pad (50) on underside of top adjustment
plate (40).
4. Repeat steps 2 and 3 to install the foam pad (50) on
the second adjustment plate (40).
Installing Adjustment Plates
Install top adjustment plates, as follows:
1. Install two flat washers (70) and two M5 X 8mm
button head cap screws (60) into the threaded holes
in the side plates (30). See Figure 5.
2. Repeat step 1 to install the second adjustment plate.
NOTE: The screws can be adjusted later when the
height of the VCR/DVD is apparent.
(40)
(70)
(60)
ADJUSTMENT PLATE (40)
ADJUSTMENT
PLATE (40)
INSTALL FOAM
PAD (50) TO
UNDERSIDE OF
TOP ADJUSTMENT
PLATE OF (40).
(50)