Chief Manufacturing CTA-100 - Manual (Page 5)

Installation Instructions CTA-100
5
INSTALLATION INSTRUCTIONS
STEP 1
Figure 2. Assemble Center Plates and Side Plates
Figure 3. Attach Center Plates and Side Plates
Assembling the Center Plates and Side Plates
Assemble center plates and side plates, as follows:
1. Locate two center plates (20) and two side plates
(30). See Figure 2.
NOTE: The two side plates fit inside the two center
plates. To assemble the unit, slide the two side
plates into the cuffed center plates.
2. Interconnect the first side plate (30) with both center
plates (20) as shown in Figure 2.
3. Repeat step 2 to interconnect the second side plate
(30) with the center plates (20).
Attaching the Center Plates and Side Plates
Attach center plates and side plates, as follows:
1. On the top, install four flat washers (70) and four
M5 X 8mm button head cap screws (60) into the
threaded holes in the side plates (30). See Figure 3.
2. Repeat step 1 to attach the side plates on the bottom
of the unit.
NOTE: The screws can be adjusted later when the
width of the VCR/DVD is apparent.
30
20
20
30
(70)
(60)