Comtrol RocketPort 550 uPCI MS-DOS - Manual (Page 5)

5
4. Enumerating the RocketPort/BroadPort 550 for use under a Windows 9x DOS
session.
The RocketPort/BroadPort 550 controllers require bus enumeration so that they can be
accessed from a Windows 9x DOS session. The procedure is similar to installing a
Windows 9x driver, and the term ‘driver’ is used however no software is actually
installed (or needs to be at this stage). The controllers are simply made known to Windows
9x..
1 . In the previous section you installed the RocketPort/BroadPort 550 and powered
up the PC
2. Windows will detect the new hardware at power up and display the:
"Add New Hardware Wizard" dialog Window.
Click Next
3. The next dialog window asks :
Search for the best driver for your device. (Windows Default)
or
Display a list of all the drivers in a specific location, so you can select the driver
you want.
ENSURE THAT SEARCH IS SELECTED
Click Next
4. The next dialog window asks where to search for the Driver.
Select Specify a location
Enter C:\ R550DOS into the dialog Window
If you extracted the driver files to an alternative folder then replace the above path with the
alternative path for the RocketPort/BroadPort 550 DOS files.
5. Windows will search the folder for the Driver
When found, the dialog displays the path to the generic ‘inf ’
file r550dos.inf
Click Next
6. On completion, Windows will display the ‘Finished Installing dialog window’
Click Finish.