Comtrol DeviceMaster Rackmount Shelf Kit User Manual
Devicemaster rackmount shelf kit installation
Table of contents
Document Outline
- DeviceMaster Rackmount Shelf Kit Installation
- Requirements
- Hardware Included
- Installation Guidelines
- DeviceMaster RTS Installation
- 1. Attach the brackets shipped with the DeviceMaster RTS to the bottom of the unit using the screws.
- 2. Place the RTS on the shelf, making sure to align the bracket holes on the RTS with the RTS mou...
- 3. Insert the flat head phillips screw from the underside of the shelf and secure the four nuts u...
- 4. Align power supply bracket (5801097) with the threaded stub and lip, and slide it into place.
- 5. Slide the power supply under the bracket.
- 6. Secure the power supply bracket with a nut (washer side down).
- 7. Align and mount the shelf into a standard IT rack using the four 5/8” round head phillips scre...
- DeviceMaster ATS Installation
- 1. If you have previously installed the brackets or rubber feet that came with the DeviceMaster A...
- 2. Place the ATS on the shelf, making sure that you align the four small countersunk holes with t...
- 3. Insert and secure the four flat head phillips screws.
- 4. Align power supply bracket (5801097) with the threaded stub and lip, and slide it into place.
- 5. Slide the power supply under the bracket.
- 6. Secure the power supply bracket with a nut (washer side down).
- 7. Align and mount the shelf into a standard IT rack using the four 5/8” phillips screws provided.
- Technical Support