Comtrol Modbus TCP Quick Start - Manual (Page 27)

DeviceMaster UP Modbus/TCP Quick Start: 2000477 Rev. G Configuring Read-Only Raw/ASCII Devices - 27
Configuring Read-Only Raw/ASCII Devices
Embedded Web Page Configuration
Use the following procedure to configure read-only Ethernet devices.
1. Access the Server Configuration web page by entering the DeviceMaster UP IP address in your web
browser or by highlighting the DeviceMaster UP in PortVision DX and clicking Webpage.
Note: If the browser does not display the web page correctly, clear the browser history and refresh the
DeviceMaster UP web page.
2. Click the Ethernet Device Configuration option to open the Ethernet Device Configuration page.
Note: The Ethernet device must be a target Ethernet device such as a barcode scanner, RFID reader,
weigh scale, or some other device that is to be connected to a PLC and/or application.
3. Click Socket N for the port that you want to configure, where N is the Socket number.
4. If desired, enter an Ethernet Interface Name.
5. Click Enable under Device TCP Connection Configuration and configure the settings for your environment
using one of the following procedures.